31
OPERATION
2.19 Reset function
Operation_Pic_number:1
Reset - initiate function.
● Press clutch pedal.
● Press push button (A).
To end Reset function.
● Stop the tractor.
● Switch ignition OFF/ON.
Text-module
When a reset is made, the following are re-
stored to their basic settings.
● Cruise control (Memory 1 - final speed, Me-
mory 2 - 10 km/h).
● Load limit control (14% reduction to rated
speed).
● Valves (valid for all valves - lift 30 l, lower
30 l, time 10 seconds, floating position ac-
tive).
● Rear lifting gear (upper limit 100% up, Trac-
tion/Position control 100% Position, lowering
speed 50%).
● Comfort front power lift (upper limit of tra-
vel 100% up, lifting speed 30 l, lowering
speed 5 l).
Fig.35
3. Heating and ventila-
tion
3.1 Heater with 3-speed blower
Operation_Pic_number:1
The heating depends on the water temperature.
Text-module
Switching on the heater (control knob B).
The control knob is ued to switch the cab heating
on/off, and for stepless adjustment to the desired
temperature.
NOTE:
If operating the air conditioning, set all con-
trol knobs to '0'.
Switch on fan (control knob A).
Fan off.
Fan speed 1.
Blower speed 2.
Blower speed 3.
Directing the air stream (control knob C).
Air outlet nozzles closed.
through air vents in the footwell.
through air vents in the footwell and in
front of the windscreen.
through air outlet nozzles in front of
windshield, recirculated air mode on at the
same time.
Fig.36
To Next Page
Loading...
Need help?
General
