211
FAULTS AND REMEDIAL ACTIONS
1.2 Fault messages
Indication accompanied by intermittent audible signal and warning lamp.
Fault codes are stored and can be called up for more accurate definition of the fault. These codes are
memorised to be called up in the workshop for rapid fault location.
Text-module
In the event of a fault message, proceed as follows:
● Make the system operative by turning ignition off-on (reset).
● If it was a temporary fault, the system is operative again.
Text-module
If the fault is displayed again:
● Call up fault code and refer to the code table for what measures to take.
Reading out a fault code
Operation_Pic_number:1
Text-module
Showing more than one fault message at the same time
Fault-module
Fault-module
Press button, fault code (B) is shown on the multiple display.
If the button is pressed repeatedly, the symbols for all existing faults are displayed one after the
other, then symbol (A), code (B), next symbol, next code, and so on. If the button is not pressed
for 3 sec., the symbol for the first fault displayed appears again.
1. Four-wheel drive
Try activating with alternate key.
Switching off may no longer be possible.
2. Differential lock
Try activating with alternate key.
Switching on may no longer be possible.
Fig.2