FENDT 926 Vario User Manual

212
FAULTS AND REMEDIAL ACTIONS
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
3. Front or rear PTO
Try engaging with another button (5 seconds).
4. EPC rear lifting gear
Move Quick Lift switch fully or turn ignition off and on again.
5. Front power lift
Move Quick Lift switch fully or turn ignition off and on again.
6. Multifunction control lever
Rear/front automatic mode on/off switch faulty.
Automatic mode stop button faulty.
7. Transmission control
Call up fault code and refer to the code table for what measures to take.
8. Sensors
No pressure, speed or volume monitoring.
It is essential to determine the cause of the fault immediately using the code table
(see FAULTS AND REMEDIAL ACTIONS Section 5).
9. Electronic system
Display accompanied by a continuous beep and warning light.
Electronic connections between components are faulty or cut. Other fault codes may
occur.
10. Indicator lamps
In the event of failure of the forward/reverse indicator lamps, the backup indicators
can be activated (see also OPERATION Section 26.5).

FENDT 926 Vario Specifications

General

Engine Power	260 hp
Transmission	Vario continuously variable transmission
Fuel Tank Capacity	500 liters
Weight	10, 500 kg
Engine type	6-cylinder turbocharged
Rated engine speed	2100 rpm
Displacement	7.5 liters
Number of cylinders	6
Maximum speed	50 km/h
Tire Options	Multiple options available