213
FAULTS AND REMEDIAL ACTIONS
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
11. Failure of (one) steering pump
Display accompanied by a continuous beep and warning light.
Steering pump or control pump failed. Reduce vehicle speed. Contact the workshop
immediately and have the fault corrected.
12. E-box (not EPC)
E-box hardware fault.
Replace corresponding E-box (at workshop).
13. Memory E-box (not EPC)
E-box basic programming invalid
(reprogramming, workshop task).
14. Front axle suspension
No longer functioning.
Suspension remains in the last position selected.
15. Emergency operation
Partial failure of the electronic monitoring system.
Use the emergency mode only to move the tractor out of potential danger or to drive
to the workshop.
16. Excessive transmission slip
Specified/actual transmission slip limit exceeded. This fault may occasionally occur
under extreme conditions (e.g. at very low gear oil temperature) even if transmission
is mechanically sound. If the problem persists in normal operating conditions, contact
the workshop immediately.
17. Hydraulic (oil level)
Hydraulic tank empty.
Valves, front power lift and rear EPC are locked.
Refill hydraulic oil or switch the valve to floating position manually, so that oil can flow
back out of the external cylinder (see also OPERATION Section 17.4).
Switch ignition OFF and ON (Reset).
18. Hydraulic valves
Valve remains incorrectly positioned or goes into neutral.
To Next Page
Loading...
Need help?
General
