FENDT 926 Vario User Manual

214
FAULTS AND REMEDIAL ACTIONS
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
19. Hydraulic valves (crossgate lever)
Valves cannot be actuated.
20. Hydraulic valves (oil temperature)
Hydraulic oil temperature too low.
Operate until the oil has warmed up and unlock the valve again.
21. Hydraulic valves (manual operation)
After manual operation, the valves cannot only be operated again with the crossgate
lever or toggle switches after a Reset (engine OFF then ON).
22. Engine coolant (level)
Level of coolant too low.
Top up with coolant.
23. Initialisation error on communication driver
CAN bus communication restricted.
24. Fault of mounted implement in implement control mode
Impossible to control the mounted implement via Vario Terminal.
Check operating manual of the implement manufacturer or contact their service.
25. Right or left draft sensing pin overloaded
Relieve right or left draft sensing pin of load.
26. Seat switch defective
In accelerator pedal mode, the driving direction must be re-entered if the tractor is in
active stationary mode.
Variotronic Ti functions cannot be played back.

FENDT 926 Vario Specifications

General

Engine Power	260 hp
Transmission	Vario continuously variable transmission
Fuel Tank Capacity	500 liters
Weight	10, 500 kg
Engine type	6-cylinder turbocharged
Rated engine speed	2100 rpm
Displacement	7.5 liters
Number of cylinders	6
Maximum speed	50 km/h
Tire Options	Multiple options available