FENDT 926 Vario User Manual

233
FAULTS AND REMEDIAL ACTIONS
4.1.44 Speed sensor engine 1 faulty. Auxiliary operation.
4.1.45 Bevel pinion speed sensor
faulty.
Auxiliary operation.
4.1.50 Transmission oil filter dirty. Auxiliary operation.
4.1.53 Transmission oil temperature
over 110°.
Damage to traction drive.
4.1.58 Slip values of transmission ra-
tios beyond acceptable limits.
Occasional occurrences in extreme con-
ditions have no effect. If the problem per-
sists in normal conditions, contact the
workshop immediately.
4.1.59 Emergency operation manually
induced or by electrical activa-
tion; emergency operation de-
fective when operated non-ma-
nually.
Fault code not in the memory.
4.1.61 Faulty activation of operating
range I valve.
Auxiliary operation.
4.1.62 Faulty activation of operating
range II valve.
Auxiliary operation.
4.1.63 Faulty activation of valve for
mechanical speed limitation.
Max. speed 30 km/h only.
4.1.64 Faulty actuation of turboclutch
valve.
Auxiliary operation.
4.1.65 Faulty activation of cardan
brake.
Call workshop.
4.1.66 Faulty activation of cardan
brake.
Call workshop.
4.1.67 Faulty activation of cardan
brake.
Call workshop.
4.1.70 Tempomat cruise control 1 key
faulty.
No Tempomat cruise control.
4.1.71 Tempomat cruise control 2 key
faulty.
No Tempomat cruise control.
4.1.72 Filter contamination switch de-
fective.
No monitoring of filter contamination.
4.1.73 Temperature output sensor
faulty.
No temperature output monitoring.
4.1.74 Parking brake position recogni-
tion switch faulty.
Hand brake position not detected, no
hand brake automatic mode.
4.1.76 Engine brake switch faulty. No engine brake function.
4.1.77 Joystick acceleration rate I-IV
faulty.
Operation only possible in acceleration
rate III.
4.1.78 Starting cut-out seat switch for
accelerator mode faulty.
Selection of direction of travel is always
deactivated in accelerator mode when
vehicle stationary for 3 seconds.
4.1.82 Plausibility error (engine
speed) between hydrostatic
unit speed sensor and bevel pi-
nion speed sensor.
Auxiliary operation.
4.1.83 Plausibility error (direction) bet-
ween hydrostatic unit speed
sensor and bevel pinion speed
sensor.
Auxiliary operation.
4.1.84 Plausibility error between the
joystick controls (F/R, Tempo-
mat cruise control).
Auxiliary operation.
4.1.85 Engine speed sensor I plausibi-
lity error.
Auxiliary operation.
Fault code Cause Effect and remedy

FENDT 926 Vario Specifications

General

Engine Power	260 hp
Transmission	Vario continuously variable transmission
Fuel Tank Capacity	500 liters
Weight	10, 500 kg
Engine type	6-cylinder turbocharged
Rated engine speed	2100 rpm
Displacement	7.5 liters
Number of cylinders	6
Maximum speed	50 km/h
Tire Options	Multiple options available