FENDT 926 Vario User Manual

234
FAULTS AND REMEDIAL ACTIONS
Text-module
Transmission
4.1.86 Plausibility error between pres-
sure sensor I and pressure sen-
sor II.
Reduced comfort.
4.1.87 Plausibility error on F/R button
on steering column.
No F/R function on steering column.
4.1.88 Plausibility error on ON/OFF
button for accelerator pedal
drive.
No function.
4.1.94 CAN communication E-Box
and joystick faulty.
Joystick functions restricted. Call work-
shop.
Fault code Cause Effect and remedy
4.1.A0 Adjuster actuation faulty. Auxiliary operation.
4.1.A1 Control unit mechanical stop
defective.
Auxiliary operation.
4.1.A2 Faulty CAN bus connection to
control unit.
Auxiliary operation.
4.1.A3 Control unit incremental sensor
faulty / not plausible.
Auxiliary operation.
4.1.A4 Adjuster EST track signal faul-
ty/missing.
Auxiliary operation.
4.1.A5 Adjuster reference not found. Auxiliary operation.
4.1.A6 Incorrect control unit reference
point during operation.
Auxiliary operation.
4.1.B0 Initialisation error on communi-
cation driver. CAN bus commu-
nication restricted.
Restricted operation.
4.1.B1 Fatal error range control with
subsequent emergency opera-
tion (e.g. valve fault).
Auxiliary operation.
4.1.B2 Transmission ratio limiting
faulty.
EOL programming.
4.1.B3 Quick Reverse acceleration
rate parameters out of tole-
rance.
EOL programming.
4.1.B4 Engine speed sensor I plausibi-
lity error.
EOL programming.
4.1.B5 Rapid reversing ramp parame-
ter for Tractor Management Sy-
stem (TMS) checksum error.
Rapid reversing not operational in the
Tractor Management System (TMS).
4.1.EO Turboclutch characteristic faul-
ty/incorrectly memorised.
EOL programming.
4.1.E1 Traction control pressure regu-
lator parameter fault/read error.
EOL programming.
4.1.E2 Pressure regulator parameters
in traction control are not plau-
sible or read in incorrectly.
No traction control function.
4.1.E3 Accelerator checksum error. EOL programming.
4.1.E4 Brake control checksum error. EOL programming.
4.1.E9 Values of operating range shift
II-I not within tolerance.
Only shift while at a standstill.
4.1.EA Incorrect EOL programming. Auxiliary operation.
4.1.EB Range-change values out of to-
lerance or range-change not
calibrated.
Auxiliary operation.
Fault code Cause Effect and remedy

FENDT 926 Vario Specifications

General

Engine Power	260 hp
Transmission	Vario continuously variable transmission
Fuel Tank Capacity	500 liters
Weight	10, 500 kg
Engine type	6-cylinder turbocharged
Rated engine speed	2100 rpm
Displacement	7.5 liters
Number of cylinders	6
Maximum speed	50 km/h
Tire Options	Multiple options available