FENDT 926 Vario User Manual

227
FAULTS AND REMEDIAL ACTIONS
3. Warning and information messages for imple-
ment settings
Operation_Pic_number:1
Warning and information messages (A) are shown on the Vario terminal.
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
1. Engine speed is less than 400 rpm
Process is not started.
Increase engine speed.
2. Transmission not in neutral
Process is not started.
Put transmission into neutral.
3. FRONT power lift/PTO automatic mode active on the
operating console
Process is not started.
End FRONT power lift/PTO automatic function on the control console.
4. REAR power lift/PTO automatic mode active on the
operating console
Process is not started.
Switch off REAR power lift/PTO automatic mode on the operating console.
5. FRONT and REAR power lift/PTO automatic mode active
on the operating console
Process is not started.
Switch off FRONT and REAR power lift/PTO automatic mode on the operating
console.
6. Variotronic Ti information message active
Fig.4

FENDT 926 Vario Specifications

General

Engine Power	260 hp
Transmission	Vario continuously variable transmission
Fuel Tank Capacity	500 liters
Weight	10, 500 kg
Engine type	6-cylinder turbocharged
Rated engine speed	2100 rpm
Displacement	7.5 liters
Number of cylinders	6
Maximum speed	50 km/h
Tire Options	Multiple options available