253
TECHNICAL DATA
4. Fuel and lubricants Vario 916 - 930
Text-module
Filling points Number Type 4) Frequency of change 2)
approx. litres
1)
Engine Fendt Extra Grade 15W-40 SHPD, Fendt
Ultra Grade 10W-40 UHPD or
after 50, 500, 1000 operating hours
Maximum fill, with change of
filter
24.0 SHPD engine oils 3) in accordance with
ACEA E3-96.
then every 500 hours of operation or
a minimum of once every year, with
fuel containing up to 0.5 % sulphur
5).
Transmission and differential
(topping up)
Fendt Extra Trans 10W-40 or every 2 years or after 2000 operating
hours.
Vario 916-920 65.0 STOU SAE 10 W-40 or 15 W-40
Vario 924-930 67.0
Lift shaft lubrication 0.2 Lifting shaft lubrication (just top up)
after 50 operating hours or if leaking.
Axle drives per side Fendt Super Trans 85W-90, 80W or every 500 operating hours
Vario 916-920 13.0 Hypoid transmission oil then every 2 years.
Vario 924-930 16.0 SAE 85W-90, SAE 80W-90, SAE 90 acc.
to API GL-5.
every 2000 op. hrs.
Front PTO 4.2 Do not use STOU or other universal oils.
Front axle Fendt Super Trans LS 85W-90 after 50 and 1000 operating hours
Differential drives 9.5 or hypoid transmission oil with LS additi-
ves.
then every 2 years or every 1,000 op.
hours
Axle hub per side 4.0 SAE 85W-90, SAE 80W-90, SAE 90 acc.
to API GL-5
Do not use STOU or other universal oils.
Rear axle shaft (optional) Hypoid transmission oil 85 W-140 in accor-
dance with API GL-5.
after 500 operating hours, then every
2 years or 2000 operating hours
Axle drives per side 16.0
Hydraulic system Fendt Super Hyd, Fendt Extra Hyd 68 or after 1000 op. hours, then every 2 ye-
ars
Quantities 70.0 STOU SAE 5W-30, 5W-40, 10W-30,
10W-40, 15W-30,15W-40
every 1000 op. hrs.
Maximum capacity 100.0 or engine oil HD-SAE 5W-30, 5W-40,
10W-30, 10W-40, 15W-30,15W-40 in ac-
cordance with API-CD.
HD-SAE 20W-20 to API-CD also allowed
for temperatures above 10 °C
Fuel tank 530.0 Diesel 5) Fill up after use.
Cooling system 26.0 water with 35 - 50 % vol. antifreeze and
anticorrosion agent 6)
Change antifreeze every 2 years.
Brake and clutch system 0.8 Pentosin CHF 11S (X 902.011.622) every 2 years.
Compressed air system 0.5 Ethyl alcohol antifreeze Fill only at temperatures below
+ 5 °C.
(X 902.015.003)
Lubrication points Fendt Ultra lithium grease, Fendt Extra
Fett EP or
see Lubrication Chart
lithium-saponified grease, NLGI class 2
(worked penetration factor 265-295). regularly oil all other joints and be-
aring surfaces.
1. Filling levels are determined with a dipstick or by
overflow at filling screws etc.
2. Whichever comes first.
4. For registered tradenames, refer to current list of
Fluids and Lubricants which is available from every
Fendt-authorised workshop.
5. If diesel fuel contains more than 0.5 % sulphur, the
oil change frequency must be halved. Below 0.05 %
we suggest to check and keep the lubricating proper-
ties by adding additives. Only use alternative fuels,
e.g. RME, once discussed with the Service Workshop.
6. Only use coolant as designated in Customer Ser-
vice memo 11/02.
Text-module
3) VISCOSITY OF ENGINE OILS
Monograde oils Multigrade oils
To Next Page
Loading...
Need help?
General
