1 Safety and requirements for product use
10 Festo – GDCP-CMMP-M0-FW-E N – 1304NH
1.2 Prerequisites for use
• Make this documentation available to the design engineer, installer and personnel responsible for
commissioning the machine or system in which this pro duct is used.
• Make sure that the specific ations of the documentation are always complied with. Also consider the
documentation for the other c omponents and modules.
• Take into consideration the regulations applicable for the destination, as well as:
– regulations and standards,
– regulations of the testing organizations and insurers,
– national specifications.
• For emergency stop applications, restart may take place only as intended under the control of a
safety switching device.
1.2.1 Technical requirements
General conditions for the correct and safe use of the product, which must be observed at all times:
• Comply with the c onnec tion and environmental conditions of the motor c ontroller specified in the
technical data ( appendix A of the documentation GDCP-CMMP-AS -M0-HW-...) and of all connec-
ted components.
Only compliance with the limit values or load limits permits operation of the product in accordance
with the relevant safety regulations.
• Observe the instructions and warnings in this documentation.
1.2.2 Qualification of the specialists (requirements for the personnel)
The device may only be set into operation by a qualified electrotechnician who is familiar with:
– installation and operation of electrical c ontrol systems,
– the applicable regulations for operating safety-engineered systems,
– the applicable regulations for acc ident protection and oc c upational safety, and
– the documentation for the product.
1.2.3 Range of application and certifications
Standards and test values which the product complies with and fulfils can be found in the “Technical
data” section ( appendix A of the documentation G DCP-CMMP-A S -M0-HW-...). The product-relevant
EU directives can be found in the declaration of conformity.
Certificates and the declaration of conformity for this produc t can be found at
www.festo.com.
To Next Page
Loading...
Need help?
General
