A Diagnostic messages
Festo – GDCP-CMMP-M0-FW-E N – 1304N H 83
A.2 Diagnostic messages with instructions for troubleshooting
Fault group 00 Invalid message or information
No. Code Message Reaction
00-0 - Invalid error Ignore
Cause Information: An invalid error entry (corrupted) was f ound in the
diagnostic memory marked with this error number.
Thesystemtimeentryissetto0.
Measure –
00-1 - Invalid error detected and corrected Ignore
Cause Information: An invalid error entry (corrupted) was f ound in the
diagnostic memory and corrected. The additional information
contains the original error number.
The system time entry contains the address of the corrupted error
number.
Measure –
00-2 - Error cleared Ignore
Cause Information: Active errors were acknowledged.
Measure –
Fault group 01 Stack overflow
No. Code Message Reaction
01-0 6180h Stack o v erflow PS off
Cause – Inco rrect firmware?
– Sporadic high proce ssor load due to cycle time being too sho rt
and special compute-bound processes (save parameter set,
etc.).
Measure • Load an approved firmware.
• Reduce the processo r load.
• Contact Technical Support.
To Next Page
Loading...
Need help?
General
