1. Installation
1−3
Festo P.BE−CPX−FB13−EN en 0811c
1.1 General instructions on installation
Warning
Before carrying out installation and maintenance work,
switch off the following:
the compressed air supply
the operating voltage supply for the electronics/sensors
the load voltage supply for the outputs/valves.
You can thereby avoid:
uncontrolled movements of loose tubing
unexpected movements of the connected actuators
non−defined switching states of the electronic
components.
Caution
The CPX field bus node contains electrostatically sensitive
components.
· Therefore, do not touch any contacts.
· Observe the handling specifications for electrostatically
sensitive components.
You will then prevent the electronics from being damaged.
Information about fitting the CPX terminal can be found in the
CPX system manual (P.BE−CPX−SYS−...).
To Next Page
Loading...
