Festo CPX-FB13 - Parameterising the CPX Terminal with STEP 7

2. Commissioning
2−46
Festo P.BE−CPX−FB13−EN en 0811c
2.2.2 Parameterising the CPX terminal with STEP 7
System parameters
1. Double click on the icon of the CPX terminal on the line of
the DP master system (see Fig.2/19 1 ). The dialogue
window Properties  DP slave" is displayed 2.
2. Select the Parameter Assignment" tab 3. The list with
the parameters and the currently active values is shown.
3. Click on the
parameter value which you wish to modify.
A list with the possible values is opened 4.
4. Modify the value by clicking it and confirm this with OK.