2. Commissioning
2−45
Festo P.BE−CPX−FB13−EN en 0811c
Fig.2/18: Fault message when the maximum number of Start parameters is exceeded
(CPX−FB13 from version 22), note the appendix A.2 Start parameters"
Note
After each interruption of the field bus system (e.g. after
interruption of the power supply to the field bus node), the
parameter set will be sent again by the PROFIBUS master
to the field bus node.
An exchange of individual CPX modules is therefore possible,
without the need for new manual parameterisation.
To Next Page
Loading...
