Festo CPX-FB13 - Settingthe DIL Switches

1. Installation
1−8
Festo P.BE−CPX−FB13−EN en 0811c
1.2.2 Settingthe DIL switches
When you have removed the DIL−switch cover, you will see
three DIL switches in the field bus node (see Fig.1/3).
You can set the following parameters with the DIL switches:
 Operating mode
PROFIBUS address
 Diagnostic mode
Proceed as follows:
1. Switch off the power supply.
2. Remove the cover over the DIL switches
(section 1.2.1).
3. Set the desired operating mode (DIL switch 1,
factorysetting: Remote I/O).
4. Assign an unused station number to the CPX terminal.
Set the desired station number (8−position DIL switch 3,
switch elements 1 Ū 7).
5. Set the diagnostic mode (8−position DIL switch 3,
switch element 8).
6. Fit the cover again (section 1.2.1).