4
Web Configuration Guide
4.4.1.4
URL Filtering
By
setting the URL filtering rules, users can forbid or allow all the
data packets sent to or received from a certain IP address. After the
fire wall is enabled, the pre-set URL filtering rule will take effect, and
the domain names that meet the filtering conditions will be filtered.
1. Select Security in the navigation bar and select Firewall→URL
Filtering in the left link bar, and then click Add to open the URL
filtering table configuration tab, as shown in Figure 4.23.
Figure
4.23 URL Filtering
2
. Configure the parameters relevant to filtering as required. Table
4.13 describes the parameters.
3. Click Apply to save and apply the configuration.
96