FiberHome AN5506-04 Series User Manual

4
Web Configuration Guide
2
. Configure the DHCP server parameters as required. Table 4.7
describes the parameters.
3. Click Apply to save the configuration information. The
configuration will take effect after the ONU is rebooted.
T
able 4.7 Parameters for the DHCP Server
Item Description
Type
Enables or disables the DHCP server.
u Server: Enables the DHCP server. The ONU can
dynamically distribute IP addresses to user terminals.
u Disable: The user terminals connected to the ONU
cannot obtain the private network IP address using the
DHCP.
DHCP Start
IP
The starting IP address of the IP
address pool of the DHCP server.
Note: The IP address
set here should be in
the same network
segment with the IP
address set in LAN
Settings; otherwise,
the DHCP server will
not operate normally.
DHCP End
IP
The end IP address of the IP
address pool of the DHCP server.
DHCP
Subnet
Mask
The mask of the active DHCP server.
DHCP
Primary
DNS
The IP address of the active DNS server.
DHCP
Secondary
DNS
The IP address of the standby DNS server.
DHCP
Default
Gateway
The default gateway of the active DHCP server.
85

FiberHome AN5506-04 Series Specifications

General

Model	AN5506-04 Series
Category	Network Hardware
Type	GPON ONT
Power Supply	12V DC, 1A
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	5% to 95% (non-condensing)
Ports	4 GE ports, 2 POTS ports
WLAN	802.11b/g/n