136 MS-9050 Series Manual — P/N 52413:F 10/22/2010
Programming Master Programming Level
Phone Line Supervision
Pressing 1 while viewing On Board DACT Screen #3 will cause the following screen to be dis-
played:
The Phone Line 2 option allows the programmer to select whether the second phone line is super-
vised. Pressing 1 while viewing the On Board DACT Screen #3 causes the display to toggle
between Yes and No. The factory default setting is Yes.
3.6.10 Password Change
The factory set passwords, which have been programmed into the control panel, can be changed by
selecting the Password Change option. Pressing 1 while viewing Programming Screen #4 will
cause the following screen to be displayed:
Press 1 to change the Master Programming Level password, 2 to change the Maintenance Level
password or 3 to change the Remote Download password. Note that the passwords will not
be dis-
played on annunciators.
The following screen will appear when one of the change options is selected:
A flashing cursor will appear in the center of the display. Enter a new five digit password (such as
10101 for the Master Level). After the fifth digit is entered, the following screen will be displayed:
ON BOARD DACT
1=SUPERV PHONE LINE
On Board DACT Screen #3
SUPERVISE PHONE LINE
1=PHONE LINE 2 YES
PROGRAMMING
1=PASSWORD CHANGE
2=CLEAR PROGRAM
3=PROGRAM CHECK
Programming Screen #4
PASSWORD CHANGE
1=MASTER
2=MAINTENANCE
3=REMOTE DOWNLOAD
Password Change Screen
ENTER NEW FIVE DIGIT
PASSWORD
Enter Password Screen
VERIFY NEW
PASSWORD
Password Change Screen
To Next Page
Loading...
