478182
39
If this appears you need to set the dispensing type of the LED AquaSmart™:
1. Press and hold down the TEMPERATURE button, then press the POWER button until
three beeps are heard.
2. Press the TEMPERATURE button to scroll through the ‘dispensing type’ options stopping at
desired ‘dispensing type’ setting.
Cold LED = No Dispensing
Warm LED = Double Dispensing (Detergent & Fabric Softener or Detergent & Bleach)
Hot LED= Triple dispensing (Detergent, Fabric softener & Bleach)
3. Press the POWER button to exit and save current setting.
For detailed fault codes (refer to section
8)
7.2 Component Testing
To select the Component Test Mode:
1. Press and hold the HI EFFICIENCY button, then press the POWER button until two beeps
are heard.
2. Press the SPIN button until all the spin LEDs are illuminated.
To operate the:
Hot Water Valve Push the REGULAR button.
Cold Water Valve Push the HEAVY button.
Detergent Valve Push the DELICATE button.
Fabric Softener Valve Push the SHEETS button
Bleach Valve Push the WHITES button.
Drain Pump Push the BULKY button.
Re-circulating Pump Push the EASY IRON button.
To turn each component off, push the same buttons that were pushed to turn them on.
7.3 Hot Bowl Flag
If the machine has been filled with the hot water valve utilised (i.e. warm or hot fill) and has not had
a cold rinse, the electronics will not allow the machine to spin up to its full speed of 1000 RPM. It
will only allow the spin speed to reach 700 RPM and the HOT LED will flash. To remove this flag,
push and hold the TEMPERATURE button until the hot LED turns off.
7.4 Restart Feature
The LED AquaSmart™ leaves the factory with the RESTART turned on.
With the RESTART feature on:
1. If a fault occurs in the machine, the diagnostic system will detect it. However, instead of
displaying a fault code immediately, the machine will try to RESTART.
2. If the fault was only of a temporary nature, the machine will restart and finish the cycle.
3. If there is a continuous fault, the machine will try to RESTART a number of times. This
process could take up to 8 minutes depending on the type of fault. After this, if the machine
still cannot restart, the fault code is displayed and the machine will beep continuously.
Dispensing Model
To turn RESTART off:
Enter the COMPONENT TEST MODE by pressing and holding the HI EFFICIENCY button,
and then press the power button until two beeps are heard.
Press the SPIN button until all the spin LEDs are illuminated.
Press the FABRIC SOFTENER button. The Fabric Softener LED will then be turned off.
When the restart feature is turned off the power button will flash when the power is on at
the wall but off at the console, indicating that the restart is in the off mode.