478182
42
7.8 Data Download
To enter the Data download mode
1. Press and hold the HI EFFICIENCY button, then press the POWER button until the machine beeps.
2. Press the START/PAUSE button. The lid lock LED will be on and flickering.
3. Place the download pen over this LED and follow the instructions supplied with the data download
program.
7.9 AquaSmart™ LED Diagnostic Table
To use this table, firstly enter Diagnostic Mode (Refer to Section 7) the different levels of information can be
extracted by using the Spin Speed button.
Diagnostic
Level
Spin Speed LEDs
Fast Med Slow Hold
Diagnostic Info Displayed
0 OFF OFF OFF OFF Last User Warning Number
1 OFF OFF OFF ON Wash Cycle Position of Last User Warning Number
2 OFF OFF ON OFF Factory use only – Not applicable to the field
3 OFF OFF ON ON Fault Code of Last Fault (if within the last 8 Wash Cycles)
4 OFF ON OFF OFF Factory use only – Not applicable to the field
5 OFF ON OFF ON Cycle Count Since Last Fault (low byte)
6 OFF ON ON OFF Cycle count since Last Fault (high byte)
7 OFF ON ON ON Wash Cycle Position of Last Fault
8 ON OFF OFF OFF Water Temperature (deg C)
9 ON OFF OFF ON Cycle Count (low byte)
10 ON OFF ON OFF Cycle Count (high byte)
11 ON OFF ON ON Motor Speed (RPM)
12 ON ON OFF OFF Water Level
13 ON ON OFF ON Factory use only – Not applicable to the field
14 ON ON ON OFF Motor Control Software Version
15 ON ON ON ON Display Software Version
Diagnostic mode 0: Last User Warning Number
The Last User Warning Number is displayed on the Wash Cycle LEDs in binary* form and can be calculated
by totalling the binary* value of the Wash Cycle LEDs.
Binary* Count User Warning
0 No Warning
1 No Taps
2 Overload
3 OOB
4 Suds
5 No Hot
6 No Cold
7 Agitate Overloaded
WASH PROGRESS
INDICATOR
DATA DOWNLOAD LED
For more information on resolving
the binary coded value from the
Wash Cycle LEDs, refer to
Section 8
POWER
START/PAUSE
To Next Page
Loading...
