478182
40
To turn RESTART on:
Enter the COMPONENT TEST MODE by pressing and holding the HI EFFICIENCY button,
and then press the power button until two beeps are heard.
Press the SPIN button until all the spin LEDs are illuminated.
Press the FABRIC SOFTENER button. The Fabric Softener LED will then be turned on.
Non-Dispensing Model
To turn RESTART off:
Enter DIAGNOSTIC MODE 2 by pressing and holding the HI EFFICIENCY button, and then
press the power button until two beeps are heard (refer to section
7).
Press the TEMPERATURE button. The Temperature LED will then be turned off.
When the restart feature is turned off the power button will flash when the power is on at
the wall but off at the console, indicating that the restart is in the off mode.
To turn RESTART on:
Enter DIAGNOSTIC MODE 2 by pressing and holding the HI EFFICIENCY button, and then
press the power button until two beeps are heard (refer to section
7).
Press the TEMPERATURE button. The Temperature LED will then be turned on.
NOTE - This feature is designed as a service aid only and should be left ON in the
customer’s home. To return to normal operation, and to reset the RESTART feature to the
factory setting, switch the machine off at the wall or disconnect from the mains supply.
7.5 Recycle Feature
At the end of servicing, the machine may require an extended test where the machine can be left
to complete a number of wash cycles. By turning on the RECYCLE feature the machine will
continuously repeat the wash cycle until the RECYCLE feature is turned off.
To turn RECYCLE on:
Enter COMPONENT TEST MODE by pressing and holding the HI EFFICIENCY button,
then press the POWER button until two beeps are heard.
Press the SPIN button until all the spin LEDs are illuminated.
Press the SOAK button. The Soak LED will then be illuminated.
To turn RECYCLE off:
Enter COMPONENT TEST MODE by pressing and holding the HI EFFICIENCY button,
then press the POWER button until two beeps are heard.
Press the SPIN button until all the spin LEDs are illuminated.
Press the SOAK button. The Soak LED will then be turned off.
To Next Page
Loading...
