478182
64
Reassembly:
(a) Prior to fitting the neck ring, ensure the
recirculating nozzle is fitted to the outer
bowl correctly.
(b) Fit the straps to the neck ring.
(c) Fit the neck ring to the outer bowl, ensuring
that all the clips are engaged.
(d) Fit the straps to the suspension rods
ensuring and that there are no twists in the
straps.
Note: The top of the nozzle must be dry
before fitting the neck ring. If any water is
present, a capillary action may take place
which will cause water to run down the
outside of the bowl and onto the floor.
10.15 Removal of Low Profile Agitator
Note: Removal of low profile agitator is not
intended to be done by the user, as regular
maintenance in this area should not be
required.
(a) Lift the lid and remove the low profile
agitator cap by using an appropriate flat
bladed screwdriver in one side of the slots.
Lever the cap upwards until it disengages.
The cap can then be removed by hand.
(b) Remove the bolt by turning anti-clockwise
using a 7/16
th
(13mm) open-ended spanner
or an adjustable spanner.
(c) Remove the low profile agitator.
Note: If the low profile agitator does not lift
off easily, hold the top balance ring of the
inner basket, and then jerk the bowl
upwards. This action will push the agitator
upwards.
The top of the nozzle must be
dry before refitting the neck ring
To Next Page
Loading...
