478182
63
10.12 Removal Of Dispensing Hoses
(a) Follow procedures for removal of inlet valve
assembly. (refer to Section
10.3).
(b) Follow procedures to raise the top deck
(refer to Section Error! Reference source
not found.).
(c) Remove hose clips from the hoses located
at the front of the top deck.
(d) Remove the hose(s).
Reassembly:
Refit in the reverse manner, ensuring each hose
is fitted to the correct position and that they are
properly clipped in place.
10.13 Removal of Straps
(a) Follow procedures for raising the top deck
(refer to Section Error! Reference source
not found.).
(b) Unclip each end of the straps from the neck
ring.
(c) Unclip the strap from the suspension rod.
Reassembly:
Refit in the reverse manner, ensuring that there
are no twists in the straps.
10.14 Removal of Neck Ring
(a) Follow procedures for raising the top deck
(refer to Section Error! Reference source
not found.).
(b) Unclip the strap from the suspension rod.
(c) Unclip the neck ring from the outer tub
assembly.
To Next Page
Loading...
