478182
62
10.10 Removal Of Softener and Bleach Funnel
(a) Lift the lid.
(b) To remove the cap, lift it upwards.
Reassembly:
Refit in the reverse manner ensuring that the
funnel is clipped fully home to ensure that the
bleach dispenser functions correctly.
10.11 Removal Of Detergent Cover
Note: Only remove the cover if it is essential to do so. If removed, the cover and the gasket
P/No 421047 must
be replaced.
Photo 1 Photo 2
(a) Lift the lid.
(b) To remove the cap, lift
upwards (Photo1).
Reassembly:
Refit in reverse manner.
Note: On removal of the
cover the retaining clips will
be damaged. If the cover is
refitted rather than being
replaced, the cover will not
provide an adequate seal, which may cause the water to fountain from the dispenser during
fill. The gasket must also be replaced for the same reason (Photo2).
To Next Page
Loading...
