478182
59
10.4 Removal of Inlet Valve Assembly
(a) Follow procedures for accessing
components in console area (refer to
Section
10.1).
(b) Remove screw securing the valve body to
the top deck.
(c) Disconnect wiring harness from each coil.
(d) Disconnect Thermistor harness from motor
control module.
(d) Depress tab from the rear of the console
and slide valve assembly upwards from the
top deck.
Refitting Valve Block:
(a) Ensure the area beneath the valve
assembly is dry.
(b) The spigots of the valve assembly must be
lubricated with a small amount of either
Petroleum Jelly or silicon paste before
insertion.
Note: The wires that are connected from the
valve assembly to the motor control module
must be placed between the coils, and must
not sit on top. If the wires sit in close
proximity to the display module and may
cause interference.
10.5 Removal of Thermistor
(a) Follow procedures for removal of Display
Module. (Refer to Section
10.2).
(b) Disconnect thermistor-wiring harness to the
Motor Control Module.
(c) Slide body of thermistor out from the valve.
Reassembly:
Refit in reverse manner, ensuring when refitting
the thermistor that the thermistor is pushed until
it comes to a stop against the back wall of the
elbow.
Thermistor
To Next Page
Loading...
