478182
60
10.6 Removal of the Cord Set
(a) Follow procedures for removal of Inlet
Valves Assembly. (Refer to Section
10.3).
(b) Disconnect the mains plug to the Motor
Control Module.
(c) Slide the strain relief to the left and slide
out.
Reassembly:
Refit in reverse manner. When refitting the
thermistor, ensure that the thermistor is pushed
until it comes to a stop against the back wall of
the elbow.
10.7 Removal of Lid Lock
(a) Follow procedures for accessing
components in console area. (Refer to
Section
10.1).
(b) Disconnect lid lock wiring harness to the
Motor Control Module.
(c) Remove Motor Control Module from the top
deck (Refer to Section Error! Reference
source not found.) leaving all remaining
harnesses and press tube connected.
(d) Remove wiring cover from top deck.
(e) Carefully remove the two lid buffers from
the front side top of the deck by levering
upward, taking care not to damage the top
deck.
(f) Remove the two screws under the buffers
securing the top deck to the cabinet.
(g) Lift the top deck upwards and remove the
screw securing lid lock to the underside of the top deck.
(h) Move the front of the lid lock downwards and outwards.
(i) Unclip the right hand rear tab of the top deck from the cabinet and raise the corner of the top
deck upwards slightly to allow the wiring harness to be removed.
Reassembly:
Refit in the reverse manner.
Slide
To Next Page
Loading...
