478182
69
Reassembly:
(a) Fit the Housing Pump O-ring to the Outer Bowl.
When replacing or refitting the pump housing, a new
O-ring must be fitted.
(c) Refit the Pump Housing.
Note: This should be done with the Pump Cap & Hood
in place, but it is not essential.
(c) Press the pump to its home position as much as
possible by hand, then use the bolts to evenly torque
the pump down.
(d) Tighten the pump bolts to a torque of 2Nm.
Note: If the bolts happen to strip when refitting the
pump housing, refer to the Pump Housing – Stripped
Pump Housing Procedure (refer to Section
11.1).
Outter Tub
Pum
To Next Page
Loading...
