Flexim FLUXUS F502TE - Deletion of Measured Values; Information Regarding the Data Logger

14 Data logger
14.5 Deletion of measured values FLUXUS F502TE
2020-05-29, UMFLUXUS_F502TEV1-5EN
104
14.5 Deletion of measured values
• Select the menu item Special Funct.\Delete Meas.Val.
• Press ENTER.
• Select yes or no.
• Press ENTER.
14.6 Information regarding the data logger
Aprox. 100 000 measurement data can be stored. Each measured value is stored with the corresponding totalizer and
optionally further measurement and diagnostic data (see section 14.3).
According to the configuration of the data logger and the stored series of measured values, the remaining data logger
capacity will be displayed in the menu item Special Funct.\Instrum. Inform.
• Select the menu item Special Funct.\Instrum. Inform.
• Press ENTER.
It is recommended to delete the old series of measured values before starting a measurement.
The type and the serial number of the transmitter are displayed in the upper line.
The remaining data logger capacity will be displayed in the lower line (here: 18 327 additional measured values can be
stored).
• Press BRK twice to return to the main menu.
It is possible to store max. 100 series of measured values. The number of series of measured values depends on the total
number of measured values stored in the previous series of measured values.
Press to scroll through the displays of the upper line.
If the ringbuffer is activated and has overflown at least once, the following display will be indicated:
Special Funct.\Delete Meas.Val.
Special Funct.\Delete Meas.Val.\Really Delete?
Special Funct.\Instrum. Inform.
Fig. 14.1: Information regarding the data logger
F502TE -xxxxxxxx
Free 18327
full= 26.01/07:39
54.5 m3/h
last= 26.01/07:39
54.5 m3/h