12 Dismounting and disposal
FLUXUS F502TE 12.1 Dismounting
97
UMFLUXUS_F502TEV1-5EN, 2020-05-29
12 Dismounting and disposal
12.1 Dismounting
The dismounting is carried out in reverse order to the installation (see chapter 6).
12.2 Disposal
The measuring equipment has to be disposed in accordance to the applicable regulations.
Warning!
Installation, connection and start-up by unauthorized and unqualified personnel
This may result in personal or material damage or dangerous situations.
→ Any work on the transmitter has to be carried out by authorized and qualified personnel.
Warning!
Touching live parts
Electric shock or arc faults can led to severe injuries. The measuring instrument can be damaged.
→ Prior to any work on the transmitter (e.g., installation, dismounting, connection, start-up), the transmitter has
to be disconnected from the power supply. It is not sufficient to remove the internal fuse of the instrument
(see section 7.2).
Caution!
Safety and accident prevention regulations for electrical systems and equipment
Failure to observe these regulations may lead to severe injuries.
→ Observe the safety and accident prevention regulations for electrical systems and equipment.
Important!
Avoid environmental damage by correct disposal of components
Depending on the material, the corresponding parts have to be disposed in residual or special waste or recycled.
FLEXIM accepts the return of the components. For further information, contact FLEXIM.
To Next Page
Loading...
