Flexim FLUXUS F502TE - Display of the Last Valid Measured Value; Displays During the Measurement

17 SuperUser mode
FLUXUS F502TE 17.10 Display of the last valid measured value
127
UMFLUXUS_F502TEV1-5EN, 2020-05-29
17.10 Display of the last valid measured value
If the signal is not sufficient for a measurement, UNDEF is normally displayed. Instead of UNDEF, it is also possible to display
the last valid measured value.
• Select the menu item Special Funct.\SYSTEM settings\Measuring\Miscellaneous.
• Press ENTER until the menu item Keep display val is displayed.
• Select on to activate the display of the last valid measured value or off to deactivate it.
• Press ENTER.
17.11 Displays during the measurement
Besides the normal information (see section 9.4) the following parameters can be displayed during the measurement in
the SuperUser mode:
Special Funct.\SYSTEM settings\Measuring\Miscellaneous\Keep display val
display explanation
t transit time of the measuring signal in the fluid
c sound speed
REYNOLD Reynolds number
VARI A standard deviation of the signal amplitude
VARI T standard deviation of the transit time of the measuring signal
dt-norm transit time difference standardized to the transducer frequency
fluid density