8 Start-up
8.1 Start-up settings FLUXUS F502TE
2020-05-29, UMFLUXUS_F502TEV1-5EN
66
8 Start-up
8.1 Start-up settings
When starting up the transmitter for the first time, the following settings are required:
• language
• units of measurement
• date/time
These displays will only be indicated when the transmitter is switched on for the first time.
The available transmitter languages are displayed.
• Select a language.
• Press ENTER.
The menus are displayed in the selected language.
• Select metric or imperial.
• Press ENTER.
• Select yes if the transmitter is to be used in the region of Canada.
• Press ENTER.
This display will only be indicated if imperial is selected.
• Select the temperature probe for the input T1.
• Press ENTER.
Warning!
Installation, connection and start-up by unauthorized and unqualified personnel
This may result in personal or material damage or dangerous situations.
→ Any work on the transmitter has to be carried out by authorized and qualified personnel.
Caution!
Safety and accident prevention regulations for electrical systems and equipment
Failure to observe these regulations may lead to severe injuries.
→ Observe the safety and accident prevention regulations for electrical systems and equipment.
Notice!
The transmitter and transducers have to be checked to ensure proper condition and operational safety before each use.
The transmitter housing must always be closed during operation. Observe that maintenance work must be concluded.
Select language
Engineer. Units
CANADA-REGION
Input T1
To Next Page
Loading...
Need help?
General
