Flexim FLUXUS F502TE - Page 129

18 Settings
FLUXUS F502TE 18.1 Dialogs and menus
129
UMFLUXUS_F502TEV1-5EN, 2020-05-29
18.1.3 Transducer distance
recommended setting: user
• user will be selected if the measuring point is always the same
• auto can be selected if the measuring point often changes
In the program branch Measuring, the recommended transducer distance will be displayed in parentheses, followed by
the entered transducer distance if the recommended and the entered transducer distance are not identical.
During the transducer positioning, in the program branch Measuring:
• only the entered transducer distance will be displayed if Transd. Distance = user is selected and the recommended
and the entered transducer distances are identical
• only the recommended transducer distance will be displayed if Transd. Distance = auto is selected
18.1.4 Steam in inlet
• Select on in case the fluid in the supply line can be vaporous during the thermal energy rate measurement (see section 19.4).
In this case, the supply pressure will have to be entered in the program branch Parameter.
• Press ENTER.
18.1.5 Temperature correction
• Select on to enable the input of a temperature correction for each temperature input.
• Press ENTER.
18.1.6 Error delay
The error delay is the time interval after which the error value is transmitted to the output in case no valid measured values
are available.
• Select damping if the damping factor is to be used as the error delay. Select edit to activate the menu item
Error-val. delay in the program branch Output Options. From now on, the error delay can be entered in the
program branch Output Options.
• Press ENTER.
18.1.7 Alarm state indication
• Select on to display the alarm state during the measurement.
• Press ENTER.
18.1.8 Units of measurement
It is possible to set the units of measurement for the length, temperature, pressure, density, kinematic viscosity and sound
speed.
• Select a unit of measurement for all quantities.
• Press ENTER after each selection.
Special Funct.\...\Dialogs/Menus\Transd. Distance
Special Funct.\...\Dialogs/Menus\Steam in inlet
Special Funct.\...\Dialogs/Menus\Tx Corr.Offset
Special Funct.\...\Dialogs/Menus\Error-val. delay
Special Funct.\...\Dialogs/Menus\SHOW RELAIS STAT
Transd. Distance
(50.8) 50.0 mm