18 Settings
18.5 Program code FLUXUS F502TE
2020-05-29, UMFLUXUS_F502TEV1-5EN
136
If a command is selected:
In order to execute a command, it is sufficient to enter the first 3 digits of the program code (= Access Code).
• Enter the first 3 digits of the program code with and .
• Press ENTER.
At first, 000000 is displayed. If the program code starts with 000, ENTER can be pressed immediately.
18.5.3 Deactivation of the program code
• Select the menu item Special Funct.\Program code.
• Press ENTER.
• Enter "------" to delete the program code.
• Press ENTER.
If the character "-" is entered less than 6 times, this character sequence will be used as the new program code.
Special Funct.\Program code
INP. ACCESS CODE
CODE: 000000
To Next Page
Loading...
