Flexim FLUXUS F502TE - Page 139

19 Thermal energy rate measurement
FLUXUS F502TE 19.2 Transmitter settings
139
UMFLUXUS_F502TEV1-5EN, 2020-05-29
19.2.2 Displaying the transmitter terminals
• Select the menu item Special Funct.\SYSTEM settings\Proc. inputs\Terminal.
• Press ENTER.
The terminals for the connection of the temperature input T1 are displayed.
• Press ENTER.
The terminals for the connection of the temperature input T2 are displayed.
• Press ENTER.
19.2.3 Selection of the temperature probe
• Select the menu item Special Funct.\SYSTEM settings\Proc. inputs.
• Select PT100/PT1000 from the scroll list.
• Press ENTER.
• Select the temperature probe for the input T1.
• Press ENTER.
• Select the temperature probe for the input T2.
• Press ENTER.
19.2.4 Activation of the temperature inputs
The temperature inputs are displayed one after another in the program branch Output Options.
• Select yes if the temperature input T1 is to be activated.
• Press ENTER.
This display will not be indicated if Thermal energy has been selected as physical quantity.
• Select yes if the temperature input T2 is to be activated.
• Press ENTER.
This display will not be indicated if Thermal energy has been selected as physical quantity.
Special Funct.\SYSTEM settings\Proc. inputs\Terminal
Input T1
Input T2
Special Funct.\SYSTEM settings\Proc. inputs
Input T1
Input T2
Output Options\...\Temperature T1
Output Options\...\Temperature T2
Notice!
If a temperature input is activated, the total number of measured values that can be stored will be reduced.