Flexim FLUXUS WW - Page 129

A Menu structure FLUXUS WW
UMFLUXUS_WWV1-1EN, 2018-02-28 129
selection of the error value delay
• damping: The damping factor will be used.
• edit: The menu item for the input of the error value delay in the pro-
gram branch Output Options will be activated.
x
activation of the display of the alarm state during the measurement x
selection of the unit of measurement for the length x
selection of the unit of measurement for the temperature x
selection whether the absolut pressure p
a
or relative pressure p
g
is to be
used
x
selection of the unit of measurement for the pressure x
selection if lb/ft³ is to be used as unit of measurement for the density x
selection of the unit of measurement for the density
This display will only be indicated if lb/ft³ has not been selected as the
unit of measurement for the density.
x
selection of the unit of measurement for the kinematic viscosity x
selection of the unit of measurement for the sound speed x
SYSTEM settings\Measuring
selection of the displays for the measurement settings
enabling the NoiseTrek mode x
enabling the NoiseTrek parallel beam mode
This display will only be indicated if the NoiseTrek mode is enabled.
x
selection whether the toggling between the TransitTime mode and the
NoiseTrek mode is to be carried out manually or automatically.
This display will only be indicated if the NoiseTrek mode is enabled.
x
input of the time after which the transmitter has to toggle to the NoiseTrek
mode if there are no valid measured values in the TransitTime mode
range: 0...9999 s
0: without toggling to the NoiseTrek mode
This display will only be indicated if the automatic toggling between the
TransitTime mode and NoiseTrek mode is activated.
x
INIT-resis-
tant
Error-val. delay
damping >EDIT<
SHOW RELAIS STAT
off >ON<
Length unit
>[mm]< [inch]
Temperature
>[°C]< [°F]
Pressure absolut
off >ON<
Pressure
>[bar]< [psi]
Density [lb/ft3]
no >YES<
Density unit
g/cm3 >kg/m3<
Viscosity unit
mm2/s >cSt<
Soundspeed unit
>[m/s]< [fps]
SYSTEM settings↕
Measuring
Enable NoiseTrek
off >ON<
NT parallel beam
off >ON<
Auto NoiseTrek ?
no >YES<
TT-Failed |After
NoiseTrek | 40s