OPERATION ST51A/ST75A/ST75AV Mass Flow Meters
34 Fluid Components International LLC
CLI Commands
Table 9 below summarizes the command line interface (CLI) commands accessible via the serial interface (computer/FC88).
When invoking a CLI write function separate the command mnemonic and the data value with a space. All Read and
Write Functions are completed by pressing [ENTER]. To exit CLI, press [ENTER] following the last Command
[ENTER] (i.e., press [ENTER] twice). Refer also to Secondary Commands: CLI on page 28.
Examples:
RBK[ENTER] (Read Breakpoint)
WBK 2222 [ENTER] (Write Breakpoint 2222)
RC11 [ENTER] (Read Coefficient C1,1)
WC11 -234.567[ENTER] (Write Coefficient C1,1, -234.567)
Table 9 – List of CLI Commands
Temp Comp, ACT_Tslope set