Fluke 9100 - Page 245

Section 4: Using the Model 9100: Thermocouple Function 4.14-3
Final Width = 215mm
4.14.3 Screen Keys
4.14.3.1 Bottom Screen Keys
THERMO
COUPLE Permits selection of other thermocouple types (paras 4.14.3.3).
TYPE
RTD Selects RTD function when Thermocouple function is active.
TEMP Selects the type of temperature scale: IPTS-68 or ITS-90 when
SCALE the Thermocouple function is active (paras 4.14.3.4).
4.14.3.2 Right Side Screen Keys
A. Digit Edit Keys operate on the temperature value.
x 10 Multiplies the temperature value by ten.
÷10 Divides the temperature value by ten.
± Reverses the polarity of the temperature value (only available when °C or
°F has been selected).
°C Converts the temperature value into degrees Celsius (only available when
°F or K is active — the '°C' key label disappears when °C is active).
°F Converts the temperature value into degrees Fahrenheit (only available
when °C or K is active — the '°F' key label disappears when °F is active).
K Converts the temperature value into Kelvins (only available when °C or °F
is active — the 'K' key label disappears when K is active).
B. Direct Edit Right side keys operate on the number in the edit box, and acting in
place of the ↵ key, exit from Direct Edit back to Digit Edit, setting the
temperature value to that shown in the box.
Temperature
°C Evaluates the number in the box in degrees Celsius.
°F Evaluates the number in the box in degrees Fahrenheit.
K Evaluates the number in the box in Kelvins.
All temperature values have the resolution: 5 significant digits with 1 decimal place.