Fluke 9100 - Page 315

Section 4: Using the Model 9100: AC Power Function - Operation 4.20-3
Final Width = 215mm
4.20.2 Selection of AC Power Function
(Manual Mode selected) Entry is via the AUX key at the bottom right of the
‘CALIBRATION SYSTEM’ panel, followed by the POWER softkey if one of the
oscilloscope calibration options (Option 250 or Option 600) is fitted.
AC Power is selected by pressing the
W vertical softkey.
Figure 4.20.2 - the Auxiliary Function selection screen.
date time
W
Ω
Ω
LOGIC°C
The display on
these areas of the
screen will depend
on the options fitted
to the Model 9100
W
W