Fluke 9100 - Page 49

Section 3: Model 9100 Controls: Modes of Operation 3-21
Final Width = 215mm
TODAYS DATE TIME
TODAYS DATE TIME
3.3.2.18 'APPENDED
MESSAGE'
Users are given the facility to enter a
new message to be appended to the
printed certificates (maximum 130
characters).
Laboratory Details required for
the Certificate
For the printed results certificates, it is
required to enter details of the
laboratory at which the results were
obtained:
Users should enter the name,
temperature and relative humidity of
their laboratory for the printed
certificates.
3.3.2.19 'LAB DETAILS'
1. On the CERT DETAILS menu
screen, press the LAB DETAILS
screen key on the right.
This transfers to what we shall
refer to as a 'LAB DETAILS'
screen
2. The lab name, temperature and
humidity can be entered via the
three screen keys on the right.
3. The EXIT key reverts to the
CERT DETAILS screen.
1. On the CERT DETAILS menu
screen, press the APPEND
MESSAGE screen key.
This transfers to 'The current
appended message' screen
2. If required, use the alpha-numeric
keypad to enter a new message
on the certificate (maximum 130
characters).
3. Press the EXIT key to revert to
the CERT DETAILS screen
Configuration
EXIT
The current appended message is:
Enter a new message:
Configuration
EXIT
Present settings
Lab name Fluke L . . .
Lab temp. 21°C ±10°C
Lab humid. 30% ±10%
LAB
NAME
LAB
TEMP
LAB
HUMID.