• OFF – no dynamic address assignment, the defined ETHERNET IP address is a fixed address
• DHCP ON – dynamic address assignment using DHCP
• BOOTP ON – dynamic address assignment using BOOTP (by means of the correct MAC address)
ETHERNET IP
sets a fixed network address for the sensor, see section 8.1 Addressing, page 63.
ETHERNET NM
sets the network mask to integrate the sensor in an existing subnet domain, see section 8.1 Addressing, page 63.
ETHERNET GW
sets the network gateway address.
ETHERNET PORT
sets the Ethernet port, see section 8.1 Addressing, page 63.
WEB SERVER
activates/deactivates the internal web server provided by the sensor.
To Next Page
Loading...
