Fluke endurance series - Messages; Table 9-1: Pyrometer Parameters; Table 9-2: Messages

Endurance
®
Series
Users Manual, Rev. 2.0, Jun 2020
68
Table 9-1: Pyrometer Parameters
Parameter
Description
Setting
Temperature unit
Set the temperature unit
Celsius
Fahrenheit
Color mode
1 , 2 color
Slope
* 1000 (0.9 → 900)
850 … 1150
Emissivity
* 1000 (0.9 → 900)
100 … 1100
Transmissivity
* 1000 (1.0 → 1000)
100 … 1100
Sensor offset
-200 … +200
Sensor gain
800 … 1200
Averaging time
* 0.1 s (1 s → 10)
0 …3000
Valley hold time
* 0.1 s (1 s → 10)
0 …3000
Peak hold time
* 0.1 s (1 s → 10)
0 …3000
Setpoint relay
in °C /°F
dev. range min. max
Deadband
1 …99
Decay rate
0 …9999
Relay alarm output control
normally open,
normally closed,
permanently open,
permanently closed
Laser control
off / on / flashing / trigger
Panel lock
locked / unlocked
Analog output mode
Set output mode
0 … 20 mA / 4 … 20 mA
Bottom temperature of output
Set bottom temperature of analog output
0…9999°C /°F
Top temperature of output
Set top temperature of analog output
0…9999°C /°F
9.3 Messages
Table 9-2: Messages
Parameter
Description
Setting
Message diagnostics alarm
The diagnostics information of pyrometer is not
transferred to the PROFINET IO controller
message inactive
is transferred to the PROFINET IO controller
message active
Message process alarm
The process alarm of pyrometer is not transferred
to the PROFINET IO controller
message inactive
is transferred to the PROFINET IO controller
message active
Behavior on module fault
set process data to zero,
set process data to last value