Fluke endurance series - Signal Reduction; Figure 15-32: Model E1 RH - Allowed Signal Reduction over Target Temperature; Figure 15-33: Model E1 RL - Allowed Signal Reduction over Target Temperature

Endurance
®
Series
Users Manual, Rev. 2.0, Jun 2020
146
15.6 Signal Reduction
The following figures show each sensor model’s percentage of allowed signal reduction at all temperatures. Refer
to these graphs to estimate what percentage of target area must be visible to the sensor at temperatures below
the minimum temperature (95% attenuation) as shown in this manual.
Figure 15-32: Model E1RH – Allowed Signal Reduction over Target Temperature
Figure 15-33: Model E1RL – Allowed Signal Reduction over Target Temperature
up to 95% allowed signal reduction
1300 to 3200°C (2372 to 5792°F)
up to 95% allowed signal reduction
800 to 1800°C (1472 to 3272°F)