12.1.8 USB/RS485 Converter (E-USB485)
The USB/RS485 converter allows you to connect your sensor to computers by using an USB interface.
Technical Data
Power supply 5 VDC direct from USB port
Speed max. 256 kBit/s
RS485 4 wire (full duplex) and 2-wire (half duplex)
(Endurance sensor supports 2-wire only)
Terminal screwed accepts 0.05 to 3 mm² (AWG 13 to AWG 30)
USB connector type B (supplied with type A to type B cable)
Ambient Temperature 0 to 60°C (32 to 140°F), 10-90% relative humidity, non-condensing
Storage Temperature -20 to 70°C (-4 to 158°F), 10-90% relative humidity, non-condensing
Dimensions (L x W x H) 151 x 75 x 26 mm (5.9 x 2.9 x 1 in)
Figure 12-9: USB/RS485 Converter
For more information, see section 7.4 Computer Interfacing, page 61.
To Next Page
Loading...
