Fluke endurance series - Table 9-6: Error Codes

Endurance
®
Series
Users Manual, Rev. 2.0, Jun 2020
70
In productive data exchange between the I/O controller and the fieldbus PROFINET IO, one byte IOPS process
data qualifiers are available for each module providing information of the validity of the pyrometer module data
(good/ bad). In the event of an error occurs during operation, the problem-indicator in APDU-Status is set by the
communicator and a diagnostic alarm is additionally transmitted.
Table 9-6: Error Codes
Bit
Description
0
Heater temperature over range
1
Heater temperature under range
2
Internal temperature over range
3
Internal temperature under range
4
Wide band detector failure
5
Narrow band detector failure
6
Energy too low
7
Attenuation for failsafe too high
8
Attenuation to activate relay too high
9
Two color temperature under range
10
Two color temperature over range
11
Wide band temperature under range
12
Wide band temperature over range
13
Narrow band temperature under range
14
Narrow band temperature over range
15
Alarm
16
Video overflow
17
PROFINET not ready
18
Heater not ready