Fluke endurance series - PC Network Adapter Setup

Endurance
®
Series
Users Manual, Rev. 2.0, Jun 2020
64
8.2 PC Network Adapter
The network adapter on the PC side can be configured as following:
1. Go to <Start> <Settings> <Network & Internet> <Status> <Change Connection Properties>
2. Under <IP Settings> <IP assignment> click on <Edit>
3. Under <Edit IP settings> select <Manual> and switch <IPv4> to On.
4. Make the following settings:
IP address: 192.168.42.x
where x is an address between 0 and 255 except 132 which is already used
by the Endurance sensor by factory default
Subnet prefix length: 255.255.255.0 (subnet mask)
Gateway: {empty}
Preferred DNS: {empty}