Flyer Mountain - Page 35

33
EN
Always remove the battery before clean-
ing, maintaining or repairing your e-bike.
Ensure that you do not touch and thus
possibly connect contacts when clean-
ing or maintaining the battery.
You risk being hurt and the battery may
su󰀨erdamageifthecontactsarelive.
Do not use a strong water jet or high-pres-
sure cleaner for cleaning. The cleaning
liquid may enter sealed bearings due to
high pressure, dilute the lubricant and in-
crease friction. As a result, rust is formed
which destroys the bearings. Cleaning
with a high-pressure cleaner may dam-
age the electrical system.
The following are not suitable for clean-
ing your FLYER e-bike:
• Acids
• Fats
• Oil
• Brake cleaner (only to use on brake
discs)
• Solvent-based liquids.
These damage the surfaces and contrib-
ute to wear on the FLYER e-bike.
After use, ensure that you dispose of the
lubricant, cleaning and care products in
an environmentally friendly way. These
substances do not belong in domestic
waste, in the drain or in natural environ-
ments.
Smooth operation and durability of your
FLYER e-bike depend on appropriate
maintenance and care for your FLYER.
• Regularly clean your FLYER with
warm water, small amounts of clean-
ing agent and a sponge.
• While cleaning the FLYER, always
check your e-bike for cracks, notches
or material deformities.
• Damaged parts must be replaced with
original spare parts. Please only ride
your FLYER again after this check
has been carried out.
• Have any paint damage removed by
your FLYER specialist retailer.
Further important information concerning care for
your FLYER e-bike is provided on the website of
the respective component manufacturer.
Speed sensor
The speed sensor is used to show the speed in
the FLYER display and correctly calculate the as-
sistance needed.
The speed sensor and the associated spoke magnet
must be fastened so that the distance between the
spoke magnet and the marking position on the speed
sensoris 1 to5 mm. Ifthe distanceisdi󰀨erent, an
error message will appear.
Powersupplytoexternaldevices
YoucanusetheUSBporttochargeexternalde-
vices, e.g. smartphones, that can be powered via
USB. The charging cable of the device can be
connected directly to the FLYER display.
Inordertochargeexternaldevices,yourFLYER
e-bike must contain a charged FLYER battery.
Open the cover of the USB port on the display
and connect the charging cable to it.
• Do not place the connected device on
a tilted or unstable place while charg-
ing. Otherwise, it could fall and be-
come damaged.
• Do not charge external devices in
rainy weather or connect a wet USB
cable. The USB connection is not wa-
terproof!
• You must not connect external de-
vices when riding in the rain and the
USB port must be completely covered
by the protective cap.
• After using the USB port, be sure to
rmlytightentherubbercap.
• Make sure that the voltage of the USB
port is suitable for your device. (See the
technical data for the voltages)