Flyer Mountain - Storing the Battery; Pushing Aid

42
5.30 Storingthebattery
When not in use for a long period of time, store the
batteryatachargelevelofapproximately30%to
60%. Check the charge level after 6 months. If
necessary, recharge the battery to about 30% to
60% capacity.
If possible, store the battery in a dry, well ven-
tilated place in temperatures between 10 °C und
40°C. For a long lifespan, it is benecial for a
battery to be stored at room temperature, around
20°C.Forexample,donotleavethebatteryinthe
car in the summer and store it away from direct
sunlight.
Thebattery mustbestored ona non-ammable
surface (stone, concrete).
Do not store the battery near combustible or
highlyammableobjects.
5.31 Pushing aid
Thepushingmakesiteasierforyoutoseto󰀨on
the e-bike. Do not use the pushing aid to ride the
e-bike.
All FLYER e-bikes are equipped with a pushing
aid. This is limited to 6 km/h in the fastest gear.
The FLYER can conveniently be moved out of
underground parking or along steep paths by ac-
tivating the pushing aid.
Switchtopushingaidmodebyrstlypressingand
holding the pushing aid button for more than 1.5
seconds. Then release the button and press the
pushing aid button again to activate pushing aid
mode.
The pushing aid is activated if
– You press the – button in the pushing aid mode
– Aspeedof6km/hisexceeded.
Push-
ing aid
When using the pushing aid, the wheels
mustbeincontactwiththeoortoavoid
the risk of injury.