Flyer Mountain - Page 38

36
Do not connect the charger to the mains
socket immediately after a sudden tem-
perature change from cold to warm. It is
possible that condensed water has col-
lected on the contacts and this will lead
to a short circuit.
Do not connect the battery to the charg-
er immediately after a sudden tempera-
ture change from cold to warm. Wait until
both devices have reached room tem-
perature before connecting the charger
or the battery. Always charge and store
the battery and charger in a dry, covered
environment and only under supervision.
2 Check the LED charge status indicator
Check whether the charge status LED is lit up.
The LED lights up according to the charge status.
ThechargestatusLEDgoeso󰀨whenthecharg-
ing process has been completed. The charging
time takes longer if the battery temperature is too
low or too high. A fully charged battery cannot be
charged any further.
During charging, the following messages may be
displayed by the battery and charger via LEDs:
The battery may not be recharged when
it indicates a fault. The battery might be
damaged after being dropped or due to
mechanical impact, even when there is
novisibleexternaldamage.
Such batteries must therefore be in-
spected by a FLYER specialist retailer.
Never try to open a battery or to repair it.
Damaged batteries must not be posted.
3Pulloutthepowerplugfromtheplugsocket
After disconnecting the battery from the charger,
disconnect the power supply plug from the wall
socket.
Beforeusingthebattery,besuretormlytighten
the rubber cap.
Insertingthebattery
First, place the battery into the lower holder of the
e-bike and move its upper part towards the ve-
hicle until the lock audibly latches into the upper
holder.
Ensure that the battery is correctly positioned in
the holder.
lower holder