Flyer Mountain - Page 40

38
ched room temperature before connec-
ting the charger or the battery. Always
charge and store the battery and char-
ger in a dry, covered environment and
only under supervision.
2)ChecktheLEDchargestatusindicator
Check whether the charge status LED is lit up.
The LED lights up according to the charge status.
Thecharge statusLED goeso󰀨 whenthe char-
ging process has been completed.
The charging time takes longer if the
battery temperature is too low or too
high.
A fully charged battery cannot be charged any
further.
The battery may not be recharged when
it indicates a fault. The battery might be
damaged after being dropped or due to
mechanical impact, even when there is
novisibleexternaldamage.Suchbatte-
ries must therefore be inspected by a
FLYER specialist retailer. Never try to
open a battery or to repair it. Damaged
batteries must not be posted.
3)Removetheplugfromthepoweroutlet
Separate the mains plug from the mains socket
after disconnecting the battery from the charger.
Itisimportantthattherubbercapisrmlyreatta-
ched before using the battery.
Safetywarningregardingthebatterycharger
The name plate refers to warning notes and other
safety information in connection with handling the
charger. It is important to read them before using
the charger.
Please note the temperature ranges of the battery
and charger:
Battery operating temperature: -5 °C to 40 °C
Battery storage temperature: 10 °C to 40 °C
Charging temperature range: 0 °C to 40 °C
Use only the original charger sup-
pliedalongwithyoure-bike. Only this
charger is designed for the lithium-ion
battery used on your e-bike.
Completely charge the battery using the
chargerbeforetherstridetoensurefull
battery performance. Read and adhere
to the operating instructions for the char-
ger when loading the battery.
The battery can at any time be charged outside
or installed in the bicycle without reducing its life
span. Interrupting the charging process does not
damage the battery.
The battery is equipped with a temperature mo-
nitor that permits charging only within a tempera-
ture range of 0 °C to 40 °C.
Separate the battery from the charger and wait
until it has reached operating temperature. Only
reconnect the charger when it has reached the
permitted operating temperature.