Flyer Mountain - Page 61

59
EN
Neverridewithaseatpostextendedfur-
ther than the maximum marker as this
could result in serious falls and injury.
Childrenandpersonswhoarenotcon-
dent cyclists should be able to touch the
ground with the tips of both feet. Other-
wise, when stopping they run the risk of
fallingandsu󰀨eringseriousinjury.
Seat position
The horizontal position of the seat can and should
be set too.
You are in the optimal riding position when your
front knee is directly above the pedal while the
crank is horizontally aligned.
The horizontal adjustment of the seat may only
be performed within the markers and within the
rangespeciedbythemanufacturer.
Test whether the seat post and the seat
arermlyattachedbeforeyourideo󰀨.
To do this, hold the seat at the front and
back and attempt to turn it. It should not
move.
Telescoping seat post
FLYER Uproc models can
besuppliedexworkswitha
height-adjustable seat post.
This allows the seat height
to be lowered or adjusted
rapidlyand safelyin di󰀩cult
terrain, for example before
big drops.
The height of the seat can lowered by operating
the switch on the handlebars while pushing down
on the seat. If you want to return to your normal
riding position, simply operate the handlebar
switchandbrieyremoveanyloadpushingdown
on the seat. The support then resets the seat to
its usual height.
ST OP
It is essential that you read the part ma-
nufacturer‘s operating manual when set-
ting up and operating suspension seat
posts and telescopic seat posts.
FLYER MT171 seat post
If your FLYER E-MTB is tted with a MT171
adjustable seat post, please note the following
points. The FLYER MT171 allows you to cycle ef-
cientlyandtackletechnicallydemandingroutes.
SAFETY PRECAUTIONS
Please read the user manual carefully before as-
sembling and using the FLYER MT171 seat post.
Failure to follow the instructions may lead to sever
injuries or death.
1. Adjusting the height of the seat post during the
ride may cause you to lose control of the seat
post.
2.Neverride onamodiedorexcessivelyworn
FLYER MT171 seat post. Do not modify the
FLYERMT171;anymodicationswillresultinthe
warranty being cancelled and may cause invisible
damage to and/or faults in the seat post.
3. Loose, overly tightened, damaged or worn
parts may cause unexpected faults. Check the
seat post regularly for wear or damage. If there
are signs of wear, cracks or dents in the seat post
or parts of it, stop using the seat post straight
away and contact an authorised FLYER dealer to
inspect, repair or replace the parts.
4.Beforesettingo󰀨,pleasemakesurethatallof
the screws in the FLYER MT171 seat post are
properly fastened to the recommended tightening
torque.
5. Fastening the seat post clamps too tightly af-
fects whether you can adjust the seat post hight;
youcanndtherecommendedtighteningtorque
on the seat post clamp or in the technical data.